Forum: Reliability & Maintainability Questions and Answers
Posted by: Min Hee
Date posted: Wed Feb 25 10:25:11 US/Eastern 2004
My question is similar point with previous question.
On reliability demonstration, I will demonstrate 0 failure at one equipment during test time. I have to determine confidence interval and I want to know what value and criteria are applied in usual case. Thanks.
Posted by: Rel Engr
Date posted: Fri Feb 20 15:16:51 US/Eastern 2004
Subject: Question on Confidence
I am planning on conducting a reliability study using time censored data assuming a Chi-Square distribution. Assuming 0 failures, I have been estimating the appropriate length for the study to maintain a desired reliability and confidence. As I am limited on study length, I am considering lowering either confidence or reliability. Although I am reluctant to reduce confidence, it seams to be the option preferred by management to maintain a high minimum reliability. I am unclear on the effect of lowering confidence and was hoping someone could go into detail on the effect.
Posted by: James Bauer (email@example.com )
Date posted: Wed Feb 11 16:58:32 US/Eastern 2004
Subject: LRU undetected failure rates
In performing a system safety analysis for an aircraft installation I used the product manufacturer's Failure Modes and Criticality Analysis as a starting point for my system level analysis. The manufaturer maintains that the undetected failure rate (failures not detected by Built In Test) for LRUs interfaced with the system can be assumed at 5% for digital components and 10% for analog LRUs. Is there any data or documentation to substantiate this position?
Posted by: Cong Nguyen (firstname.lastname@example.org )
Organization:DRS Technologies-Signal Solutions
Date posted: Thu Jan 29 13:36:22 US/Eastern 2004
Subject: Service Life
Please show me how to calculate "Service Life" of an electronic product. I appreciate your help very much.
Sincerely, Cong Nguyen
Posted by: Johnson
Date posted: Mon Jan 12 22:46:23 US/Eastern 2004
Subject: RDF 2000 (UTEC 80810)
I'm look for the standard of RDF 2000 (UTEC 80810) from France Telecom. Dose anyone know how to get it? Any information about calculation of tunnel reliability of Optical Transmission Network will be welcomed. Thanks.