SRC Forum - Message Replies


Forum: Reliability & Maintainability Questions and Answers

Topic: Reliability & Maintainability Questions and Answers

Topic Posted by: Reliability & Maintainability Forum (src_forum@alionscience.com )
Organization: System Reliability Center
Date Posted: Mon Aug 31 12:47:36 US/Eastern 1998

Back to message list Show all replies Topics List About this forum
Original Message:

Posted by: Mark Urban (murban@sdlcomm.com )
Organization:SDL Communications
Date posted: Thu Jan 21 13:57:05 US/Eastern 1999
Subject: Burn-in
Message:
Does burn in today buy you anything? We currently perform a static burn in with after burn test defects around 0.001%. Dynamic burn in has been suggested. What about HALT testing on prototypes and eliminating burn in on production lots. Any input would be much appreciated. Thanks, Mark


Reply:

Subject: Burn-In
Reply Posted by: Bruce Dudley (bdudley@alionscience.com )
Organization: Reliability Analysis Center
Date Posted: Thu Jan 21 15:33:49 US/Eastern 1999
Message:
Looking at your low defect rate of 0.001%, it seems that the static burn-in test is either not stressing the units sufficiently or the quality is great. A dynamic burn-in test could add additional stress. If you continue to find few failures with a stress increased static test or a new dynamic test, then you should consider stopping the burn-in entirely. Burn-in testing is a functional test if there are lots of defects. On the other hand, HALT testing is usually done to find design and component deficiencies, not manufacturing and vendor defects.


Reply to this message
Next reply