SRC Forum - Message Replies

Forum: Reliability & Maintainability Questions and Answers

Topic: Reliability & Maintainability Questions and Answers

Topic Posted by: Reliability & Maintainability Forum ( )
Organization: System Reliability Center
Date Posted: Mon Aug 31 12:47:36 US/Eastern 1998

Back to message list Show all replies Topics List About this forum
Original Message:

Posted by: Bob Valerius ( )
Organization:Northrop-Grumman Oceanic Systems
Date posted: Tue May 9 13:17:46 US/Eastern 2000
Subject: One Shot Device Reliability
What kind of analysis is reasonable to ask a vendor to supply to support a Probability of Success Requirement (>0.99999) for a one shot device? Thanks in advance!


Subject: One Shot Device Reliability Analysis
Reply Posted by: Jack Farrell ( )
Organization: Reliability Analysis Center
Date Posted: Thu May 11 11:36:51 US/Eastern 2000
Given the high degree of reliability required for your device, >.99999, verification by test would require a very large sample size. A test of this magnitude would not be reasonable for obvious reasons. A more reasonable approach would be to calculate the failure rate for your device and then estimate its reliability for a given life cycle. Since your device is a one-shot I would expect the failure rate due to dormant environmental conditions to be significant. I would ask your vendor to develop failure rates for both dormant and operation modes. Using the reliability function R(t) = e^(-lt), where "l" is the device failure rate for a given period and "t" is the length of the time period, I would solve R(t) for both the dormant period and the operational period. Your device reliability would then be the product of the R(t-dormant)and R(t-operational). Please note that only the exponentially distributed failures occurring during the device’s useful life are considered. Failures due to design inadequacies, manufacturing problems, and wear out are not considered.

Reply to this message