SRC Forum - Message Replies

Forum: Reliability & Maintainability Questions and Answers

Topic: Reliability & Maintainability Questions and Answers

Topic Posted by: Reliability & Maintainability Forum ( )
Organization: System Reliability Center
Date Posted: Mon Aug 31 12:47:36 US/Eastern 1998

Back to message list Show all replies Topics List About this forum
Original Message:

Posted by: Henry Davis ( )
Organization:Honeywell DAS
Date posted: Fri Feb 26 17:11:33 US/Eastern 1999
Subject: MIL-HDBK-217
We are in process of updating reliability predictions from previous revisions of MIL-HDBK-217. Specifically from 217 Rev C, and 217 Rev F to 217 Rev F, CN2.The question is what would be the anticipated deltas in failure rate between the different models. If specific information is not available, then I would appreciate any general comments relating to this subject. We would like to use this as a sanity check for the results we are obtainig.


Subject: Mil-Hdbk-217
Reply Posted by: Bruce Dudley ( )
Organization: Reliability Analysis Center
Date Posted: Wed Mar 3 9:52:29 US/Eastern 1999
We at the Reliability Analysis Center have not done a specific delta failure rate change analysis for the various revisions to Mil-Hdbk-217. In general, the part failure rates have decreased with improved quality control procedures. As a rough measure, I estimated that from version "C" to "F" the equipment level failure rate would be improved by a factor of 8 and from "F" to Notice #2, the improvement would be about 2. These estimates are based on a sample of the failure rates from each book and then averaged using the part population mix as shown in the Reliability Toolkit, Commercial Practices Edition.

Reply to this message