SRC Forum - Message Replies


Forum: Reliability & Maintainability Questions and Answers

Topic: Reliability & Maintainability Questions and Answers

Topic Posted by: Reliability & Maintainability Forum (src_forum@alionscience.com )
Organization: System Reliability Center
Date Posted: Mon Aug 31 12:47:36 US/Eastern 1998

Back to message list Show all replies Topics List About this forum
Original Message:

Posted by: Dianne Keating (keatingd@engr.mun.ca )
Date posted: Wed Jul 4 12:25:03 US/Eastern 2001
Subject: Quality Level
Message:
I am using RELEX to preform some reliability analysis and I was just wondering if someone could tell me how to determine the quality level for capacitors, resistors and diodes. For example for a ceramic chip capacitor you can select from D, C, S, R, P, M, L. What do these letters stand for? And how do I determine which one to use? Thanks!


Previous reply
Reply:

Subject: Quality Level
Reply Posted by: Paul Jaworski (pjaworski@alionscience.com )
Organization: Reliability Analysis Center
Date Posted: Thu Jul 5 12:31:52 US/Eastern 2001
Message:
These letters are quality levels with an associated quality factors from MIL-HDBK-217 rev F n. 2, pg. 10.1 and are based on known quality levels for capacitors. For military approved parts the quality level is stated within the part number. Refer to the appropriate military standard for part marking descriptions. If you are using a commercial part, use the 1.0 factor or non-established reliability 3.0. There other quality levels for resistors and diodes. Enclosed is the quality table from MIL-HDBK-217 Quality Factor Established Reliability Styles D…………………………………………0.001 C…………………………………………0.01 S,B……………………………………0.03 R…………………………………………0.1 P…………………………………………0.3 M…………………………………………1.0 L…………………………………………1.5 Non-Established Reliability…………………….3.0 Commercial or Unknown Screening Level……10.0 NOTE: Established reliability styles are failure rate graded (D, C, S, etc.) based on life testing defined in the applicable military device Specification. This category usually applies only to three-letter styles with an "R" suffix. You can attain a copy of MIL-HDBK-217 at: http://stinet.dtic.mil/str/dodiss4_fields.html For future reference on RELEX you can go to RELEX at http://www.relexsoftware.com/feedback.asp or call (724) 836-8800.


Reply to this message
Next reply