SRC Forum - Message Replies


Forum: Reliability & Maintainability Questions and Answers

Topic: Reliability & Maintainability Questions and Answers

Topic Posted by: Reliability & Maintainability Forum (src_forum@alionscience.com )
Organization: System Reliability Center
Date Posted: Mon Aug 31 12:47:36 US/Eastern 1998

Back to message list Show all replies Topics List About this forum
Original Message:

Posted by: Lim (limth@cet.st.com.sg )
Date posted: Thu Jul 18 3:54:01 US/Eastern 2002
Subject: ESS for Fine Pitch SMT components
Message:
Hi, My company is currently using fine pitch SMT components in one of our products. We practise ESS whereby we subject products to Random vibration of 20-1000Hz with a Grms of about 6g. However, because of these fine pitch components used, we are concerned that the mentioned vibration profile will damage the product. Does anyone have any experience in this area whcih they can advise. Is there any specific profile to use? Tks.


Reply:

Subject: ESS Vib on SMT
Reply Posted by: Joe Dzekevich (jdzekevich@ieee.org )
Date Posted: Fri Jul 19 8:37:57 US/Eastern 2002
Message:
The correct process would be to do a HALT test on your product and find both the operational and destruct limits. Then, derating from the operational limits, set your ESS and/or HASS/HASA profiles. Then take a sample of products and do a proof of screen for 10-20 cycles and ensure no damage except for defects. Using this process, I have not had any problems with fine pitch SMT, even at levels higher than 6 Grms. Other components, like large profile caps, connectors, etc. will break first.


Reply to this message
Next reply