SRC Forum - Message Replies

Forum: Reliability & Maintainability Questions and Answers

Topic: Reliability & Maintainability Questions and Answers

Topic Posted by: Reliability & Maintainability Forum ( )
Organization: System Reliability Center
Date Posted: Mon Aug 31 12:47:36 US/Eastern 1998

Back to message list Show all replies Topics List About this forum
Original Message:

Posted by: Shanta
Date posted: Mon Mar 5 15:36:45 US/Eastern 2007
Subject: HALT test motors
Does anybody know how to perform a HALT test on motors? We are trying to simulate the wearout of bearings and brushes. The motor manufacturer data sheet claims the MTBF of bearings is 50000 hours under nominal load conditions at 10000rpm. There is no description of what "nominal load condition" is. We would like to test this claim. How do we set up the test? Thanks for all the help in advance.

Previous reply

Subject: Motor Reliability Testing
Reply Posted by: bwd
Date Posted: Mon Mar 5 17:16:26 US/Eastern 2007
The nominal load conditions are usually stated as the 50% loading point for most motors. This load point is generally derived by use of 50% of maximum current. This 50% current condition sets the maximum life point which in your case is 50,000 hours. By increasing the load current to 100% or near 100% you will stress the motor and accelerate your testing. The level of acceleration requires research on the failure mechanisms and modes of motors, which is one of the technical areas that SRC performs.

Reply to this message